Motor on 1152, on the three-phase ladder. Now I'm not going to edit anything at all.

So if I click there like that, what will happen now is I get Insert/Edit Component. Now I'm going to place it deliberately on the end there, on this wire. So select it like so, and then it says specify insertion point. Now you'll notice you've got a 1 Phase Motor, but you've also got over here 3 Phase Motor. So we go to Motor Control here, and what we've got is some motors here that are available to us. And what we're going to do, we're just going to place a three-phase motor on the end of those three wires. So make sure it's Icon Menu from the flyout there. We're then going to go to the Schematic tab on the ribbon, and we're going to go to the Icon Menu in the Insert Components panel. You want to be at the end of this multiple bus wiring here. And you want to make sure that it's kind of to the left like that. So we're going to zoom in, and as you can see, it's the one that starts at 1150. Zoom in on this one here, the ladder that we placed, and the multiple bus wiring. We've got our two three-phase ladders with the multiple buses coming off of them going horizontally to the right. How do we do that? Well, let's just roll back on the wheel a few notches. What we need to look at now is placing three-phase components. Now, we've placed wires and ladders so far. Once again, we're staying in our DEMO11.dwg file in our WDDEMO project, and we're looking at our multiple bus wiring and multi-phase wiring, three-phase wiring, and so on.

Autocad electrical heater symbol